GSi PNEG-2023, Руководство по установке

Страница: 15 / 30

3. Installation
PNEG-2023 Metric In-Line Mount and Cross-Cut Mount Flush Style Intermediate Discharge Gates 15
Cut Trough Bottom for Gate Placement
1. Start by locating the center of the proposed discharge location. Dimension “A” shown in Figure 3B .
2. If holes cannot be aligned, new holes must be drilled in the trough side bottom flanges.
3. Dimension “B” would be 2413 mm (95") for in-line gates or 1163.65 mm (45.813") for cross-cut gates.
4. Center this dimension “B” around the point found with the dimension “A” and cut the bottom as
straight as possible on either side of the center.
5. Weld the extra angle iron flanges (3) provided with the gate to each trough bottom cut, as shown
in Figure 3B , so that the gate can be bolted to each side. Stitch weld edges 51 mm (2") long with
38 mm (1-1/2") spacing.
6. Remove the burrs on the inside edge of the trough bottom.
7. Apply paint to welds on the outside of the trough.
Figure 3B
Ref # Description
1 Conveyor Bottom
2 Weld these two edges stitch weld 50.8 mm (2") long 38.1 mm (1-1/2") spacing.
3 Angle Iron Flanges