Chapter 4: Flashing Installation
3. After floor (19) is in place, place 1-1/4" bin bolts (14) through the pre-punched holes in the sidewall
(9). Refer the below figure to determine the correct sequence for placing the spacer nuts (18) and
flat washers (17).
NOTE:
Bolt (14) heads should be on the outside of the bin.
4. Finger tighten the spacer nuts (18) until all flashing (13) is installed, then go back and fully tighten.
5. While holding the flashing (13) flat and pushing in towards the sidewall (9), fasten the flashing (13)
to the floor (19) with two sheet metal screws (15).
Figure 4-2
Corrugation details
9
Sidewall
17
Flat washer
13
Flashing
18
Spacer nut
14
1-1/4" bin bolt
19
Flooring
15
Sheet metal screw
24
PNEG-223
60' Cor-Lok and Cut-Lok Flooring
Содержание 60' DIAMETER
