GSI Group PNEG-1451, Руководство по установке

Страница: 61 / 118

6. 2.66" Corrugated Commercial Hopper Tank 10-22 Rings
PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks 61
Intermediate and Base Safety Cage Hoop Assembly
Before attaching any pieces to the ladders or platform, some pre-assembly is required. Attach the safety
cage brackets to the ladder section. (See general detail information
on Page 12 .) Bolt the safety cage hoop
adjuster plates (C) onto the extension angle (E) as shown in Figure 6V . Bolt the safety cage hoop
adapters (B) and safety cage hoop halves together using the proper holes based on the diameter of the
grain bin.
(See Page 55.) Be sure to use the 5/16" x 3/4" bolt with the head of the bolt to the inside of the
safety cage. Bolt these assemblies to the safety cage brackets and hoop adjuster plates (C), tighten bolts
as you go. The bottom assembly requires two (2) hoop halves and will be positioned just below the
platform as shown in
Figure 6V . Use the safety cage hoop adjuster angle (D) to secure the two (2) hoop
half (A) assemblies to the vertical entrance angle (F) on the platform assembly.
NOTE: See Pages 56 and 57 for vertical supports, safety cage and bell cage installation details to
complete the intermediate ladder assembly.
Figure 6V
Ref # Part # Description
A LDR-4201 Safety Cage Hoop Half
B LS-5284 Safety Cage Hoop Adapters
C LS-5285 Safety Cage Hoop Adjuster Plate
D LS-6776 Safety Cage Hoop Adjuster Angle
E LS-6775 Extension Angle (See general detail information on Page 12 for proper installation.)
F Vertical Entrance Angle (See platform assembly on Page 52 .)
G 4' Ladder Sections
H 48" Typical Bottom to Bottom
I Right Hand Platform Assembly ( See Page 52 for assembly details.)
J Safety Cage Hoop Bracket (See general detail information on Page 12 for proper installation.)