20
PNEG-1020 Bin Sweep Auger
6" and 8" Bin Sweep Assembly & Installation
2. Install both top motor mount clip and both
bottom motor mount clip onto the motor
mount rods with a two (2) 3/8" x 2-1/2"
carriage bolt, lock washer and nut.
Figure 4.10-B
3. Insert the threaded ends of the motor
mount rods into the motor mount. The
motor mount rods should be facing away
from the pulley as shown in
.
Figure 4.10-C
4.11 Install the Pivot Pin
Extension (If needed)
1. Slide the pivot pin extension over the
pivot tube located on the motor mount
assembly.
Figure 4.11-A
4.12 Install the Bin Sweep into
the Bin
1. After removing all grain from the center
well and intermediate well, place the bin
sweep auger in the bin.
2. Place the pin, located on the sweep
motor mount, into the tube provided on
top of the well.
3. Lay the sweep auger on the pile of
sloping grain.
4. Use the extension tube between the
motor mount and the bin well, if desired.
5. Attach the suitable electric wiring to the
motor in a manner that will permit the
sweep to rotate around the bin.
Note: The motor starting controls must be
located outside the bin. They must
NEVER be installed on the sweep
inside the bin.
Top Motor
Mount Strap
Bottom Motor
Mount Strap
Motor Mount Rods
Pulley
Pivot Pin
