9
ASSEMBLY INSTRUCTIONS
6. Turn the three spreader diverters
outward (Figure 2). The diverters
on the blade assembly are turned
inward for shipping purposes.
Further adjustments may be re-
quired after installation.
7.
Use two 5/16"-18 x 1.1/4" bolts,
four 5/16" flatwashers, two 5/16"
lockwashers, and two 5/16"-18
nuts to fasten each of the three
hanger brackets inside the
spreader cone (Figure 3). The
five mounting slots provided in
the hanger brackets are used for
adjusting the spreader up and
down inside the bin. Location is
dependent on several factors
such as interference with stirring
systems and grain bouncing off
spreader motor onto bin roof.
8. Measure bin opening (hatch col-
lar) to select correct slots for bolt-
ing hanger extensions to hanger
brackets. All GSI bins with stan-
dard peak roof cap have a hatch
collar diameter 31.1/2". Loosely
mount each hanger extension to
a hanger bracket, using the ap-
propriate slots with two 5/16"-18
x 1.1/4" bolts, two 5/16" lock-
washers, four 5/16" flatwashers,
and two 5/16"-18 nuts (Figure 3).
9. Add 3/8" eyebolt to the top of
motor.
10. Compare assembled unit with
parts assembly drawing (page
11) to make certain that all parts
are properly installed.
Turn spreader diverters
SPD-2003
Note: Remove blade extention
(SPD-2002) for 24' & smaller bins
Figure 2: The diverter segments on the blade.
Figure 3: The spreader cone connection to the hanger bracket.
Hanger bracket
SPD-2010
Adjustable
5/16" Flatwasher
5/16"-18 x 1.1/4"
Bolt
5/16"-18 Nut
5/16" Lockwasher
5/16"-18 Flatwasher
Figure 4: The hanger bracket connection to the hanger extension.
5/16"-18 Nut
5/16" Lockwasher
5/16" Flatwasher
Hanger bracket
SPD-2010
Adjustable
5/16"-18 x 1.1/4" Bolt
5/16" Flatwasher
Hanger extension
SPD-2008