15
To change the tilt angle of your display, hold the display firmly in place and loosens
the top screws on either side of the mount. Set the display to the desired position, and
then re-tighten the screws (see Fig. 11). Do not release the display until the screws are
fully tightened and never fully loosen or remove these screws.
Swivel adjustments can be made by grasping the display firmly and moving it to the
desired position. Be careful that fingers or cables do not get pinched when moving the
mount.
Level correction adjustments can be made by simply rotating the display in the needed
direction. If it is too difficult to move the display or if the display does not stay in position
once moved, adjust the tension of the three nuts located behind the front of the mount
using the S10 socket wrench (I) provided in the hardware kit (see Fig. 12). Do not fully
loosen or remove these nuts.
Periodically clean your mount with a dry cloth. Inspect all screws and hardware at regu-
lar intervals to ensure that no connections have become loose over time. Re-tighten as
needed.
Operation and adjustment
