ENGLISH
17
Connecting the WT-AV 1 Transmitter
Note:
Use the cinch/EURO-AV cable labelled ”for Transmitter”.
1
Insert the EURO-AV plug of the cable in the EURO-AV socket of the signal
source (e.g. DVD player).
2
Insert the cinch plug of the cable in the cinch socket of the transmitter.
– Yellow – video signal, red – audio signal right, white – audio signal left.
3
On the channel switch »
CH
« select a transmission channel by sliding a
switch into the »
DIP ON
« position.
The other switches must remain in the upper position.
4
Insert the jack plug of the infra-red module into the »
IR
« socket.
5
Remove the protective film of the adhesive tape from the infra-red receiver
and attach the infra-red receiver to the infra-red sensor of the signal
source (e.g. DVD player).
Note:
For the correct position of the infra-red sensor of the signal source, see the
operating instructions for the signal source you are using.
When attaching the
i
nfra-red receiver, make sure that the infra-red sensor
of the signal source is not completely covered. This might make direct
operation of the device via remote control impossible.
The second
i
nfra-red receiver can be used for another device.
6
Insert the mains adapter plug into the »
DC 9V
@
« socket.
7
Insert the mains adapter in the socket.
8
Position the antenna upright.
CONNECTION
______________________________________
DIP ON
I
2
3
4
ǵ
X
e n a r o
VIDEO IN
R • AUDIO • L IN
IR
CH
DC 9V
DIP ON
I
2
3
4
ANT
CH
DIP ON
I
2
3
4
1
2
3
4
5
6
7
8
