ķ
23
Rectifying Faults Y
ourself
Fault
Possible cause
Rectification
Does not function
No power supply
Check mains power plug
No picture or sound.
EURO-AV cable loose
Insert plugs at receiver and
TV set
TV set not in AV setting
Switch TV set to AV
Aerial is not aligned to a satellite
Align aerial to required satellite
(see assembly instructions
for aerial)
Poor aerial cable connections
Check cable connections
Defective LNB
Replace LNB
Incorrect reception range of LNB
Replace LNB
Incorrect LNB oscillator frequency in menu Correct the oscillator frequency setting
(see page 13)
Picture has spikes.
All stations from this satellite
Aerial not aligned exactly
Align aerial exactly
are disturbed.
LNB oscillator frequency is shifted
Optimize allocated LNB frequency (see
“Preselecting LNB oscillator frequencies,
page 13).
Satellite blocked by trees, bushes, etc.
Remove obstacles or change aerial place.
Dish too small
Use the picture and sound improvement
function (see chapter “Using the
Receiver”, page 10).
Aerial cable too long
Use Inline amplifier
Cable contacts poor or damp
Check contacts
Only on this station
Input frequency not tuned in
Retune frequency (see “Selecting the
correctly
transmission frequency of a station” on
page 12 and “Finetuning the reception fre-
quency for reception unit B” on page 16.
Stations do not correspond to
LNB oscillator frequency entered
Enter LNB frequency of used LNB
station table.
incorrectly
optimize if necessary
(see page 13).
Aerial directed at bad satellite.
Correct aerial alignment
Remote control does not function
Receiver receives no remote control
The receiver’s display must be visible,
commands (may be obstructed by an object)
direct the remote control at the receiver.
Batteries empty or polarity reversed
Replace batteries or reverse polarity
Universal remote control
Remove battery, press any button
programmed incorrectly
several times and replace battery. The
basic setting (see chapter on “Universal
Remote Control” on page 6) is automati-
cally set.
Receiver programmed for remote
Press the
¢
SAT 2
key and the
control mode 2 (see page 20)
desired function key.
Reception unit B cannot be controlled.
Timer active
Wait until the Timer has elapsed
or
abort the Timer, see page 18 (internal
Timer) or page 19 (external Timer).
