Grundig SM 3330, Руководство пользователя

Страница: 9 / 13

9 ENGLISH
Preparation
Caution­
█
Switch off the appliance and disconnect from
supply before changing accessories or ap-
proaching parts that move in use.
1­­
Remove all packaging and sticker materials
and dispose of them according to the appli-
cable legal regulations.
2­­ Take the entire unit of the motor housing
F
and place it on a level surface, e.g. on the
kitchen counter.
Caution­
█
The blade unit is very sharp! Handle the blade
unit with utmost care, especially during clean-
ing, in order to avoid injuries.
3­­ Clean all parts, with the exception of the
motor housing
F
as described in “Cleaning
and Care”.
4­­ Then re-assemble the jug blender in the re-
verse order.
5­­ Put the plastic jug
D
on the motor housing
F
.
Note
█
Make sure that the notches on the bottom of
the plastic jug D fit those in the motor hous-
ing
F
.
Blending­
1­­
Place the device on an even and dry surface.
The non-slip feet
I
ensure the stability of the
appliance.
2­­ Make sure that the power cord is discon-
nected from the power supply.
3­­ Remove the plastic jug
D
from motor housing
F
; to do this, turn the plastic jug
D
in an anti-
clockwise direction and lift it upwards; open
the cover
C
.
4­­
Now put the ingredients to be blended in the
plastic jug
D
. The ingredients should only be
about 2-5 cm long.
Notes
█
Add water to ensure the jug blender functions
smoothly.
█
Mix 3 units of hard food and 2 units of water
in order to have a smooth jug blender experi-
ence. (i.e: 60 gr hard food 40 ml water)
Caution­
█
Do not put or blend hot food or liquids in the
plastic jug
D
. If you process soup, make sure
that the liquid temperature does not exceed
40°C.
█
Never let the jug blender operate while empty
(without food).
█
Never let the jug blender operate without the
plastic jug on the motor housing
F
.
5­­ Close the cover
C
. Ensure that the cap
A
is
located and secured in the cover opening B .
To close, turn in a clockwise direction.
6­­
Place the plastic container
D
upright on the
motor housing
F
and turn in a clockwise di-
rection.
Caution­
█
Never move or turn the plastic jug after it is
properly seated in the place.
7­­
Connect the power plug to a suitable power
outlet.
8­­
Press the required cutting speed
G
or
H
.
Notes­
█
To operate the blender at the low speed, turn
the control dial to “1”.
█
To mix at a high speed, press the speed regula-
tor
H
to “2”.
█
To add ingredients during operation: Add the
ingredients through the opening in the cover
C
. To do this, turn the cap
C
in an anti-
clockwise direction and remove.
Caution­
█
Never run the blender for longer than 1 minute,
otherwise it would overheat.
█
After running the appliance for 1 minute, let it
cool down before using it again.
OPERATION­ ______________________________