GRUNDIG Service
1 - 9
Allgemeiner Teil / General Section
RR 740 CD / RR 770 CD
2. Gehäuseoberteil abnehmen
- Gehäuserückwand abnehmen (Pkt. 1).
- 2 Schrauben
E
und Schraube
F
herausdrehen (Fig. 3).
- Die beiden Abdeckungen
G
(Fig. 3) abnehmen und die darunter
liegenden Schrauben herausdrehen.
- Schraube
H
herausdrehen (Fig. 5).
- Abdeckungen
C
und
D
(Fig. 2, 3 und 4) abnehmen:
Die Abdeckungen werden durch Rastnasen gehalten und sind
zusätzlich
an den
markierten
Stellen
verklebt
. Abdeckungen
C
und
D
an den Punkten
I
(Fig. 6 und 7)
vorsichtig
abhebeln . Diese
Abdeckungen
vorsichtig
nach oben biegen (bei Bedarf die Abdek-
kungen durch
vorsichtiges
Abhebeln ganz abnehmen) und
Gehäuseoberteil herausziehen (Fig. 8 und 9). Wenden Sie zuviel
Kraft auf, können Rastnasen oder die Blende brechen! In Fig. 2 und
4 sehen Sie die Anordnung der Rastnasen.
- Steckverbindungen nach Bedarf lösen.
2. Removing the Top of the Cabinet
- Remove the rear of the cabinet (para 1).
- Undo the 2 screws
E
and the screw
F
(Fig. 3).
- Remove the two covers
G
(Fig. 3) then undo the screws located
below.
- Undo the screw
H
(Fig. 5).
- Remove the covers
C
and
D
(Fig. 2, 3 and 4):
The covers are held in place by locking lugs and are
in addition
glued
at the
marked
spots.
Carefully
lift off the covers
C
and
D
at
the points
I
(Fig. 6 and 7).
Carefully
bend up these covers (if
necessary remove the covers completely by
carefully
lifting them
off) then pull out the top part of the cabinet (Fig. 8 and 9). If you apply
too much force the locking lugs or the trimplate might break! Fig. 2
and 4 show the locations of the locking lugs.
- If necessary undo the connectors.
H
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
D
I
I
C
D
C