Grundig M 1100, Руководство пользователя, Страница: 26 / 49

ENGLISH
26
SETTINGS
---------------------------------------------------------------------------------------------------------------------------------------
Automatic station search for FM
radio stations
After connecting the hi-fi system to the mains
power for the first time, you can start the auto-
matic station search.
1 Switch on the hi-fi system by pressing » 8 « or
» « on the device or » 8 « or »
FM
« on the
remote control.
Note:
7
If you switch on the hi-fi system with » 8 « or
» « on the device, select with » « the
TUNER input source.
2
Activate the automatic station search by press-
ing » «.
– Display: »
AUTO INST
« for a short time.
– The device searches for up to 40 stations
with strong reception and stores them auto-
matically. After the search has finished, you
will hear the station stored at preset 01.
Notes:
7
You can cancel the automatic station search
by pressing »
7
«.
7
You can restart the automatic station search
by pressing »
PROG
« until the frequency
display changes to rapid run-through.
Setting and storing radio stations
manually
1 Set the radio station by briefly pressing
»
3
« or »
4
« repeatedly.
– Display: the frequency changes in steps of
50 kHz;
or
press and hold down »
3
« or »
4
« until
the frequency changes to rapid run-through.
2 Save a radio station as a preset by pressing
»
PROG
«, selecting the preset with » « or
» « and then press » PROG « to save.
3 To search and save more radio stations, re-
peat steps 1 to 2.
Setting the time
1
To set the time in standby mode, press and
hold »
¥
« for about 2 seconds.
– Display: »
CLOCK SET
« and then »
CLOCK
24 H «.
2
Select the hour format (12 or 24 hours) by
pressing » « or » « and confirm with
»
¥
«.
– The hours flash.
3 Set the hours by pressing » « or » « and
confirm with »
¥
«.
– The minutes flash.
4 Set the minutes by pressing » « or » «
and confirm with »
¥
«.
– Display: the current time.
Notes:
7
Some RDS stations transmit an RDS time
signal. If the selected RDS station transmits
time information, the time can be updated
automatically.
Press » INFO « repeatedly until the time is
displayed. If »
RDS CLK
« displayed, the
time signal has not yet been received.
Please wait until the time is displayed.
If the correct time is displayed, press and
hold » « to confirm it.
7
The time must be reset after a power failure
or after disconnecting from the mains.