Grundig GCI-K1627D, Руководство пользователя

Страница: 52 / 98

The <Pre-trigger buffer> recording function allows users to check what happened to trigger the alarm. The pre-
trigger buffer time range is from 1 to 20 frames.
On the other hand, the <Post-trigger buffer> is for uploading a certain amount of images after the alarm input is
triggered. The post-trigger buffer time range is from 1 to 20 frames.
Check the box <Continue image upload> to upload the triggered images during a certain time or keep uploading
until the trigger is off.
- Select <Upload for __sec> and enter the duration in the blank. The images of the duration will be uploaded via
E-Mail when the alarm input is triggered. The setting range is from 1 to 9999 seconds.
- Select <Upload while trigger is active> to keep the images being uploaded via E-Mail while the trigger is active,
i.e. until the alarm is stopped.
Set the Image frequency as the upload frame rate. The setting range is from 1 frame to 15 frames.
NOTE: Normally, the setting range of the <Pre-trigger buffer> is 1 to 20. However, the setting range will change
accordingly if the frame rate of MJPEG on the <Video Frame Rate> setting page is 6 or smaller.
NOTE: Make sure SMTP and/or FTP configuration has been completed. See section 9.5. Mail and 9.6. FTP for
further details.
- Upload image to SD card:
Enable the SD card recording by ticking the box next to “Upload image to SD card”.
Pre-trigger buffer: The device will send designated frame numbers before the event (1~20 frames).
Post-trigger buffer: The device will send designated frame numbers after the event (1~20 frames).
File Name :
The uploaded image’s filename format can be set in this section. Please select the one that meets your
requirements (please see the section "File Name" in 9.8. 'Application (Alarm Settings)').
Save :
After completing all the settings mentioned above, please click on the Save button to save all the settings in this
page.
50 English