GRUNDIG Service
CINEMO DR 5400 DD
1 - 4
Servicehinweise
Achtung: ESD-Vorschriften beachten
Vor Öffnen des Gehäuses Netzstecker ziehen.
Leitungsverlegung
Bevor Sie die Leitungen und insbesondere die Masseleitungen lösen,
muss die Leitungsverlegung zu den einzelnen Baugruppen beachtet
werden.
Nach erfolgter Reparatur ist es notwendig, die Leitungsführung wieder
in den werkseitigen Zustand zu versetzen um evtl. spätere Ausfälle
oder Störungen zu vermeiden.
DVD-Laufwerk
Bei Ausbau der DVD-Lasereinheit oder der Servo-Leiterplatte müs-
sen vor Abziehen der Steckverbindungen zwei Schutzlötstellen auf
der Leiterplatte der Lasereinheit angebracht werden, um eine Zerstö-
rung der Laserdioden durch statische Aufladung zu vermeiden.
Beim Einbau einer neuen Lasereinheit (DVD-Laufwerk) müssen
nach Einstecken der Steckverbinder die werkseitig angebrach-
ten Schutzlötstellen entfernt werden!
Service Hints
Attention: Observe the ESD safety regulations
Disconnect the mains plug before opening the set.
Wiring
Before disconnecting any leads and especially the earth connecting
leads observe the way they are routed to the individual assemblies.
On completion of the repairs the leads must be laid out as originally
fitted at the factory to avoid later failures or disturbances.
DVD Mechanism
When removing the Laser pick-up or the Servo PCB, the Laser pick-
up PCB must be provided with two protective soldered joints before
unplugging the connectors to avoid damage to the Laser diodes by
static charges.
When inserting the new Laser pick-up (DVD drive mechanism) the
soldered joints fitted at the factory must be removed after the
connectors are plugged in.
Schutzlötstellen
Protective soldered joints
Fig.1
Kindersicherung deaktivieren
Die Kindersicherung kann mit dem Code "8888" deaktiviert werden.
DVD/CD auswerfen bei defektem Schubladenantrieb
DVD/CD-Laufwerk ausbauen.
Auswurfhebel an der Laufwerkunterseite in Pfeilrichtung drücken
(Fig.2).
Parental Lock
To deactivate the parental lock please use code "8888".
Remove DVD/CD with defektive Tray Drive
Remove the DVD/CD mechanism.
Push the ejector lever at the lower side of the mechanism in direction
of the arrow (Fig.2).
Fig.2
Содержание Cinemo DR 5400 DD
