When installing and using this electrical equipment, basic
safety precautions should always be followed, including
the following:
The installer must ensure that this control and its wiring
are isolated and/or shielded from strong sources of
electromagnetic noise. Conversely, this Class B digital
apparatus complies with Part 15 of the FCC Rules and
meets all requirements of the Canadian Interference-
Causing Equipment Regulations. However, if this
control does cause harmful interference to radio or
television reception, which can be determined by
turning the control off and on, the user is encouraged
to try to correct the interference by reorienting or
relocating the receiving antenna, relocating the receiver
with respect to this control, and/or connecting the
control to a different circuit from that to which the
receiver is connected.
CAUTION: The non-metallic enclosure does not
provide grounding between conduit connections. Use
grounding type bushings and jumper wires.
CAUTION: Improper installation and operation of this
control could result in damage to the equipment and
possibly even personal injury. It is your responsibility
to ensure that this control is safely installed according
to all applicable codes and standards. This electronic
control is not intended for use as a primary limit control.
Other controls that are intended and certified as safety
limits must be placed into the control circuit.
WARNING!
All field wiring to be low voltage. Power
for control is provided through the power
cord supplying power to the pump. Use
copper conductors only. Disconnect all
power sources prior to servicing
.
Risk of electric shock
. This pump is supplied
with a grounding conductor and grounding-type
attachment plug. To reduce the risk of electric shock,
be certain that it is connected only to a properly
grounded, grounding type receptacle.
Page 2
