English (GB)
12
11. Start-up
The following instructions presuppose that the controller has
been installed according to section
, and that the
pump set has been correctly connected to the controller.
The pump set must be prepared for start-up according to the
installation and operating instructions for the pump and electric
motor. Set the pressure switches to the pressure values required.
See the installation and operating instructions for the pressure
switches.
The pump set is now operational and in automatic mode.
Warning
Start-up must be carried out by authorised
personnel. Do not touch any current-carrying
parts when the cabinet door is open.
Warning
Also observe the safety instructions and start-up
procedure in the installation and operating
instructions for the electric motor and the pump.
Note
Before starting up the system, check the
tightness of the screw terminals of the controller
and signal transmitters.
Step
Illustration
1. Set the main switch to
"I".
2. Set the selector switch
to "Test" by means of
the key.
3. Open the isolating valve on the suction side of the pump.
Close the isolating valve on the discharge side of the pump.
Open the isolating valve of the test pipe.
4. Start the pump
manually by pressing
[Start]. Press the
button until the pump
starts.
Note:
If the pump does not start, see section
and
.
5. As soon as the pump starts, check the direction of rotation.
The correct direction of rotation is indicated by arrows on
the pump housing. When looking at the pump shaft, the
pump should turn counter-clockwise.
6. Slowly open the isolating valve on the discharge side of the
pump. To vent, loosen the vent plug in the discharge line.
As soon as liquid escapes, retighten the air vent screw to
25 Nm (1/2") or 30 Nm (3/8"). When the pump reaches
operating pressure, open the isolating valve sufficiently to
reach the duty point.
7. Stop the pump
manually by pressing
[Stop].
8. Set the selector switch
to "Auto" by means of
the key.
9. Close the isolating valve of the test pipe.
Step
Illustration
Содержание EPC 300
