Grundfos E-Box 500, Инструкция по установке и эксплуатации

Страница: 7 / 88

English (GB)
7
3.2.2 Selection of industrial Ethernet protocol
The industrial Ethernet protocol can be set via the
rotary switch. See fig.
4 , pos. 6.
3.2.3 Connection of power supply and GENIbus
Prior to connection of power supply and GENIbus,
execute the mechanical installation.
See section
3.3 Mechanical installation .
See fig. 5 .
1. Switch off the power supply of the DDA dosing
pump (1).
– Wait for approx. 20 seconds before executing
the next step.
2. Remove protective cap from BUS input of the
pump.
3. Connect plug (4) thoroughly to BUS input of the
pump.
Fig. 5 Connecting E-Box to SMART digital S
DDA
3.3 Mechanical installation
The E-box is always mounted below the pump
regardless of the pump's mounting position (e.g. wall
or tank mounted). See fig.
6 .
1. Place pump on E-Box.
– Make sure that the clamps of the E-Box
housing cover engage at pump housing (detail
1).
– Insert locking device (5) at pump housing
(detail 2).
2. Tighten screw (4) to lock connection (detail 3).
Fig. 6 Mounting pump on E-Box
For horizontal installation, the E-Box can be mounted
on the mounting plate of the DDA dosing pump. See
fig.
7 .
Fig. 7 Mounting E-Box on mounting plate
Pos. Description
0 PROFINET IO (factory setting)
1 Modbus TCP
5...E
Reserved. LED1 will be permanently red
to indicate an invalid configuration.
F
Resetting to factory settings.
Note: Set the rotary switch to this position
for 20 seconds to reset to the factory
settings. During this period LED1 will be
flashing red and green.
Note
If the switch position is changed when the
module is powered on, the module
restarts.
TM
04
8
442
43
11
Note
Start-up procedure and wiring diagram of
plug, see installation and operating
instructions of the SMART digital S DDA
dosing pump.
The functional profile can be found on the
product CD delivered with the E-Box.
TM
04
84
38
43
11
TM0
4
843
7
4
3
11