MODE
AUTO
16
17
MANUAL MODE:
Press the
MODE
key to switch to manual mode. Once the unit is in
MANUAL
mode, press the
START
key to run pump, press the
STOP
key to stop pump.
NOTE: In manual state, the unit doesn’t receive signal from
float
switch
or pressure switch.
AUTO MODE:
Press the
MODE
key to switch to auto mode. Once the unit is in
AUTO
mode,
the pump will start or stop according to the signal from sensor ( float switch
or pressure switch).
FAULTS AND PROTECTION:
During pump running, if dry run, overload, under voltage, over voltage etc.
failures happen, the control unit immediately stops the pump, displays it on the
LCD screen and automatically executes a check for restarting conditions after a
built-in time delay has elapsed. The control unit recovers automatically until all
the abnormal conditions have been cleared. However, the recovery time of the
control unit is different for different faults.
Details of recovery times for each fault have already been explained in this
manual. Recovery time for dry run and overload can be altered and set as per
needs. However, recovery times and values for under and over voltage are factory
NOTE
:
In
the
mode, if the pump is running and user wants to stop the pump, press
key to switch to
MANUAL
mode and pump will stop running.
In
AUTO
mode, if the input power gets cut off and when the supply gets
restored, the unit will start operating after 10 seconds automatically.
No matter the unit is in
AUTO OR MANUAL
mode, the unit will resume
operation in same mode when the power supply gets recovered after a cut off.
BASIC OPERATION
set and can’t be altered.
NOTE: To reset immediately without waiting for recovery time, cut off
power supply and again switch on.
