6.6 Approvals for ALPHA 15-55 HWR-D
Approval marks
FCC sections
Section 15.19 (a) 3
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Section 15.21
Any changes or modifications to this equipment
not expressly approved by the party responsible
for compliance could void the user's authority to
operate this equipment.
Section 15.105 (b)
This equipment has been tested and
found to comply with the limits for a
class B digital device, pursuant to Part
15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between
the equipment and receiver.
•
Connect the equipment to an outlet on a
circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced
radio/TV technician for help.
This equipment complies with FCC/IC radiation
exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency
(RF) Exposure Guidelines and RSS-102 of the IC
radio frequency (RF) Exposure rules. This
equipment should be installed and operated
keeping the radiator at least 8 in (20 cm) or more
away from person's body.
Cet équipement est conforme aux limites
d'exposition aux rayonnement définies par la
norme FCC / IC pour un environnement non
contrôlé et est conforme aux directives
d'exposition de la FCC en matière de
radiofréquences et la norme RSS-102, des règles
d'exposition aux radiofréquences (RF) de l'IC. Cet
équipement doit être installé et utilisé en
maintenant le radiateur à au moins 8 in (20
cm) du corps de la personne.
Canadian ISED information
These devices (ALPHA 15-55 HWR-D, Push-
button HWR-D, Temperature sensor HWR-D and
Repeater HWR-D) contain license-exempt
transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development
Canada’s license-exempt RSS(s). Operation is
subject to the following two conditions: 1.This
device may not cause interference. 2.This device
must accept any interference, including
interference that may cause undesired operation
of the device. Innovation, Science and Economic
Development Canada ICES-003 Compliance
Label: CAN ICES-3(B)/NMB-3(B).
L’émetteur/récepteur exempt de licence contenu
dans le présent appareil est conforme aux CNR
d’Innovation, Sciences etDéveloppement
économique Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée auxdeux conditions suivantes : 1.
L’appareil ne doit pas produire de brouillage; 2.
L’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d’encompromettre le fonctionnement.
Étiquette de conformité à la NMB-003
d’Innovation, Sciences et Développement
économique Canada : CAN ICES-3(B)/-3(B).
These devices (ALPHA 15-55 HWR-D, Push-
button HWR-D, Temperature sensor HWR-D and
Repeater HWR-D) comply with Industry Canada
RSS-247 and license-exempt RSS standard(s).
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may
cause undesired operation of the device.
Ce dispositif est conforme à lanorme CNR-247
d'Industrie Canada applicable aux appareils radio
exempts de licence. Son fonctionnement est sujet
aux deux conditions suivantes: (1) le dispositif ne
doit pas produire de brouillage préjudiciable, et (2)
ce dispositif doit acceptertout brouillage reçu, y
compris un brouillag e susceptible de provoquer
un fonctionnement indésirable.
13
English (US)
