DANGER
Electric shock
Death or serious personal injury
‐
This pump is supplied with a
grounding conductor and
grounding-type attachment plug. To
reduce the risk of electric shock, be
certain that it is connected only to a
properly grounded, grounding-type
receptacle in accordance with the
National Electric Code and any
state, local governing codes and
regulations.
DANGER
Electric shock
Death or serious personal injury
‐
If national, state or local legislation
requires a GFCI (Ground Fault
Circuit Interrupter) or equivalent in
the electrical installation, this shall
be type A or better, due to the
nature of pulsating DC leakage
current.
A Type-A GFCI is identified by this symbol:
TM072832
The motor is protected by the electronics in the
control box and requires no external motor
protection.
•
Check that the supply voltage and
frequency of the installation site correspond
to the values stated on the pump.
•
Only connect the pump to the power
supply with the line cord supplied with the
pump.
•
Do not modify and only use the line
cord supplied.
•
The "Power ON" symbol indicates that the
electrical supply has been switched on.
4.5.1 Connecting the line cord
TM072125
Fig.
Inserting the line cord plug into the
pump (side view)
To connect the line cord with the pump:
1.
Align the line cord plug with the pump.
2.
Insert the line cord plug into the pump as
shown.
3.
Push the line cord plug into the pump.
4.5.2 Removing the line cord
1
2
3
TM072126
Fig.
Removing the line cord plug from the
pump (bottom view)
To remove the line cord from the pump:
1.
Insert a 1/8 inch flat blade screwdriver into
the slot.
2.
Twist the screwdriver.
3.
Pull the cord to remove it.
5. Starting up the product
5.1 Venting the system
WARNING
Hot water
Death or serious personal injury
‐
If the hot water temperature is too
high, it can cause severe burns or
scalding.
‐
To prevent burns or scalding, be
sure to limit the temperature of the
hot water source before you vent
the system.
To vent the system:
1.
Turn on the water supply to the hot water
source.
2.
Verify that there are no leaks in any of the
connections.
3.
Turn on the tap/faucet furthest from the hot
water source until there is a steady stream of
water with no evidence of air in the system.
10
English (US)
