2
Charger Input Power
110 V AC 60 Hz / 220 V AC 50 Hz
Battery Output Power
19.2 V
Battery Capacity
1.5 Ah
Battery Pack Charge Time
1 Hour
Maximum Operating Pressure
6,000 PSI (413 PSI)
Grease Reservoir Capacity
14 oz (400 gms) / 450 gms*
Flow Rate
3 oz / minute (85 gms / minute)
Hose Length
30”
Automatic Air Bleeder
Yes
Filling Method
Cartridge Loading / Bulk Fill / Filler pump
SPECIFICATION
WARNING & PRECAUTIONS
CHARGING THE BATTERY PACK
1. Use complete safety gear (rubber gloves, safety shoes, ear
plugs, safety goggles, hard hat etc.). Avoid electric shock by
avoiding direct contact with grounded components such as
pipes, couplers etc.
2. Keep your hair, clothing, and gloves away from moving parts.
Keep hands clear of the exposed rubber portion of Hose.
3. Do not operate this gun in explosive atmospheres such
as in the presence of flammable liquids, gases, or dust. It
may create sparks leading to fire causing personal injury &
material damage.
4. The water entering the electric grease gun will increase the
risk of electric shock. Do not handle the charger, its power
plug, or the Grease Gun with wet hands or in damp locations.
5. To avoid accidental starting, always release the Switch before
connecting the grease gun to electrical supply.
6. Remove any metal tool attached to the grease gun before
turning the power on. A wrench or a key that is left attached
to a moving part of the gun may cause personal injury.
7. Always maintain your grip & balance while operating the gun.
8. Use only APPROVED hoses and follow whip hose instructions
and warnings.
9. If there is leakage from the pressure valve while using the
gun, it indicates that the back pressure is more than 6,000
PSI. It is not a product failure. It is an indication that the gun
is not to be used for this application. Please DO NOT try to
adjust the pressure valve as it has been set as 6000 PSI.
Please DO NOT try to remove the valve, as this may lead to
accidents.
For best performance, do not recharge the new battery unless
it is completely discharged. Recharging the battery pack before
its complete discharge will reduce the total work life of the pack.
All New guns come with 80% charge from the factory and no
charging is needed until it is used and the battery is run down.
•
Before using Grease Gun
for the fist time, if the
battery pack is installed
in the gun, remove it
by depressing the two
battery release buttons
(one button on each side
of battery pack) and pull
battery pack out of gun.
IMPORTANT:
Battery temperature will increase during and shortly after use.
Allow the battery pack to cool to room temperature before
charging otherwise batteries may not accept a full charge.
•
Insert the Battery Pack
into the Charging Socket
of the Charger. Then,
plug the Charger into
the nearest, grounded,
electrical outlet.
•
To start charging, press
the “Set” button on
the Charger. A green
light indicates that the
battery is charging. After
termination of the charging
(approx. 1-2 hours), pull
charger out of socket and
remove battery.
Set
Button
As a battery pack approaches the discharged state, the tool
performance drops. This is the right time to recharge the battery
pack. Recharging the battery pack before this condition is reached
will reduce the total work life of the pack. Discharging the pack
beyond this point can damage the pack.
Release Buttons
* On Australian Model
