7
www.growonix.com
toll free 888.406.8521, office 818.510.0264, [email protected]
7
Built in the U.S.A.
INSERT TUBE INTO FITTING
Push the tubing through the collet and dual
o-rings until it bottoms out against the tube stop.
The collet holds the tube in place and the dual
o-rings provide a leak resistant se
al.
MAKE A CLEAN TUBE CUT
Cut the tube squarely and if using plastic tubing,
ensure that the cut has not made the tube out of
round.
Also ensure that the tube has a smooth outside
diameter without any burrs or score marks prior to
inserting it into the fitting.
TEST AND INSPECT
Push and pull the tubing toward and away from
the fitting to ensure that it has been installed
properly.
Test and inspect the installation for any leaks.
TUBE REMOVAL
Relieve pressure from the tubing and fitting. Push
uniformly around the collet flange against the
fitting body while pulling the tubing away from the
fitting to release it.
O-RING COLLET TUBING
PUSH COLLET IN
PULL TUBE OUT
GROWONIX WATER FILTERS USE QUICK CONNECT FITTINGS
THAT ALLOW FOR EASY MAINTENANCE.
INFORMATION ON QUICK CONNECT FITTINGS
*
*
Do not use unit with inlet water pressure exceeding 80 psi. If inlet water pressure is too
high, install water pressure regulator before the unit. Pressure regulators are available at
GrowoniX.com or your local plumbing supply.
A minimum of 40psi is recommended to operate GrowoniX water filters. If your inlet water
pressure is too low, a booster pump can be used to increase pressure.
Slower performance may be noted in areas with colder temperatures, higher water
salinity, or lower inlet water pressure.
Keep unit away from direct light. Direct light can cause algae and other biologicals to
grow inside of the filter housings.
Do not install unit near electrical outlets or electrical devices.
Do not install in places where a leak can cause damage.
Do not use a flow restrictor other than the one included with your unit.
PRECAUTIONS
