HOTRONIX
®
FUSION
™
H O T R O N I X
®
F U S I O N
™
1.
6
1.1
S E R V I C E H O T L I N E : 8 0 0 . 7 2 7 . 8 5 2 0 H O T R O N I X . C O M
Connecting the System
Connect the power cord into the IEC inlet located in the back of the Press. (1.1)
Connect the opposite end of the cord into a properly grounded electrical outlet with a sufficient amperage rating.
Voltage
120 Volt - The Hotronix
®
Fusion
™
requires a full 20 amp grounded circuit for
120 volt operation.
220 Volt - The Hotronix
®
Fusion
™
requires a full 10 amp grounded circuit for
220 volt operation.
Extension Cords
If used, extension cords should be as short as possible and not less than
12 gauge. Heavy duty cords are recommended.
Circuits
Circuits that have less than 15 amps or that have other high demand equipment or appliances
(especially more than one heat seal machine) plugged in, should not be used.
Note:
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly qualified
person in order to avoid hazard. Use SJT type, rated 300 V for replacement.
CAUTION
Failure to follow these instructions will cause:
1.
Erratic controller functions.
2.
Inaccurate displays and slow heat-up.
3.
The circuit breaker to disengage.
To avoid burns, do not touch the heated platen
during use.
Keep hands clear of the upper platen of the press
during platen lock down as the pressure may
cause injury.
Press should be placed on a sturdy, suitable stand
at least 36″L x 24″W x 29″H.
Work area must be kept clean, tidy and free of
obstructions.
Power supply cord must be disconnected before
cleaning or servicing press.
O p e r a t i n g I n s t r u c t i o n s
The Hotronix
®
Fusion
™
Operating Instructions are designed with the user in mind. Carefully read and follow the
step-by-step instructions for best results.
