Current & Voltage
Measure
Overload Protection
Sounder 12V
Reader 12V
Reader 5V
12V => 5V
Current & Voltage
Measure
Overload Protection
Current & Voltage
Measure
Overload Protection
12V Lock 1
(4 Amp max)
12V Lock 2
(4 Amp max)
Up to 8 Amp
12V IN
(from Controller)
12V/24V
External Lock
Supply
Input Power
The Advance 2-Door Blade draws 12V power from the
controller. The 2-Door Blade power draw is summed
as follows:
2-Door Blade Quiescent Current = 83 mA max @12V
(1.0W)
External Reader Current (200mA max @ 5V and/or
500mA max @ 12V)
External Door Lock Current (= 4A max per Lock @
12V)
Status LED
The main Blade LED Indicator is used to indicate
activity and state (see also the status LED on the
controller).
If the LED is continuously red, the 2-Door Blade is not
communicating with the controller.
Blade State is reported by fl ashing a code on the LED
every 15 seconds as follows:
5 blue fl ashes
Board is not being monitored.
Probably no download to
controller from Sateon
5 red fl ashes
Wrong device type confi gured, e.g.
a door is defi ned on an I/O Blade
3 red fl ashes
Out of range device confi gured,
e.g. Input 3 defi ned when it only
supports 2
5 green fl ashes
No devices confi gured for board
5 yellow fl ashes
Reports electrical issues, such
as current tripped, over voltage,
under voltage, over current, under
current
Blade LED indicators
Blade Activity is reported as follows:
Yellow fl icker (lasts
about 30 seconds)
Firmware download in
progress
Green blink (every 5
seconds)
Board running OK
Blue blink
Read
Yellow blink
Input state change
Red blink
Output state change
Other LED Indicators
There are three diagnostic red LEDs on a 2-Door
Blade. Note that these LEDs cannot be seen when the
controller and Blade are in the enclosure.
LED2 – Lock 1 Power. This will be on if Door 1 on the
Blade has not been defi ned or if the Lock 1 power
current limit has been tripped
LED3 – Lock 2 Power. This will be on if Door 2 on the
Blade has not been defi ned or if the Lock 2 power
current limit has been tripped
LED4 – Reader Power (includes other connections,
such as sounders). This will be on if the Blade has
not been defi ned or the current limit has been
tripped
External Lock Supply
For systems with 24V door locks, or locks requiring
more power than the controller can provide, the
2-Door Blade supports an external lock power supply.
This operates automatically if available, where the
Blade will fi nd the external lock power supply for the
locks, otherwise, it uses internal power. This cannot be
changed without powering off .
External lock power is separate from the controller
power. It will need an independent back-up if required:
it is not supported by the controller battery.
Power Options
Page 2
