18
The charger cannot be used during rain, snow or heatwave (if used outdoors) and cannot be supplied
with power from a generator.
SYMBOLS ON GD 10 Li CHARGER:
Battery discharged – the red LED is blinking
Battery is charged – the green LED is blinking
Battery charged at 100% - the green LED is lit
Battery temperature is incorrect – the red LED is lit
SYMBOLS ON GD 18 Li CHARGER:
Battery discharged – the red LED is blinking
Battery is charged – the green LED is blinking
Battery charged at 100% - the green LED is lit
Battery temperature is incorrect – the red LED is lit
TOOL STARTING:
Pay particular attention to the battery voltage at which the device operates. Voltage and current sourc-
es must comply with the parameters specifi ed on the rating plate.
To start the tool:
1.
Press the ON switch (4)
2.
The tool cannot be locked for continuous use.
3.
To turn off – release the switch (4).
BATTERY
Battery life is about 500 cycles long which allows for full charging and discharging of the battery.
Charged battery, which has not been used for half a year, will discharge completely. In order to keep the
power level in the battery, charge it from time to time (more often than once every six months).
Store the battery in a dry and cool place. Temperatures above 40°C can lead to overheating of voltaic
cells and reduce their battery life. Temperatures below 0°C can damage the voltaic cells and reduce its
capacity.
Battery capacity drops with each charging cycle. Too short battery running time can indicate its com-
plete consumption.
CLEANING AND MAINTENANCE:
Any maintenance works or repairs requiring removal of the engine housing must be done by the main
service provider or by authorised service providers.
Keep the tool and the handles dry and clean. Keep clear of grease and oil. Venitalion slots should not
be obscured.
Apply damp cloth to the outer surfaces of the casing. Do not use running water or sprayers.
Use compressed air regularly to clean all the elements of the tool for both external and internal parts.
Check regularly all the external parts of the tool and control the proper functioning of the switches.
Do not use the tool if any of its parts is broken or a switch does not work properly.
Wiertarko-wkretarka_GD18Li_Full_v04_HR.indd 18
Wiertarko-wkretarka_GD18Li_Full_v04_HR.indd 18
2016-10-19 03:49:42
2016-10-19 03:49:42
