26
TECHNICIAN’S MENU
The technician’s menu is entered by turning the mains switch on while holding
the left console button down. Firmware versions of 3.3 and below only show the
firmware version and have no further options. The right console button changes
the displayed setting or executes it. Settings are saved immediately. This mode
can only be left by turning off the mains switch.
FIRMWARE VERSION
Shows the firmware version. We may ask for it, in order to troubleshoot your device.
MAGNET MONITOR
When turned OFF, the machine will not check whether the magnet is present, flew out,
is stuck or otherwise has a problem. You can set it to “OFF” when you want to avoid
annoying messages when needling the scalp.
SWAP WARNING
When turned OFF, the machine will not warn about the importance of setting the
correct number of cartridge needles. A convenient speedup for clinicians.
SHOW HALL VALUE
Shows the magnetic sensor’s measured value. Usually, when it is closest to 500, the
magnet is present. When it is closest to 510, there is no magnet in the hand unit.
MAGNETMISSINGCNT
Never change this value unless asked to by our support.
DLT-HALLTRESHOLD
Never change this value unless asked to by our support.
STARTPULSELENGTH
Never change this value unless asked to by our support.
HALLMARGINFFNPLS
Never change this value unless asked to by our support.