Grohe Ondus 38 915, Руководство пользователя

Страница: 9 / 92

6
Maintenance
Inspect and clean all components and replace if necessary.
Use the cistern TPI to maintain the cistern parts.
Replacing the switched-mode power supply , see fold-out
page III, Fig. [25].
1. Switch off voltage supply.
2. Disconnect extension cable (D) from upper part (A3).
3. Detach upper part (A3) of the switched-mode power supply.
4. Locate and engage new upper part.
5. Connect upper part (A3) to extension cable (D).
6. Switch on voltage supply.
Replacing the servo motor , see fold-out page III
Shut off water supply.
1. Remove wall plate, see Fig. [23].
2. Disconnect plug-in connectors from electronics (C) to
extension cable (D) and to servo motor (P), see Fig. [26].
3. Detach lift rod (O) from lever (P2), see Fig. [27].
4. Remove bracket with servo motor (P) from crossrail (U).
5. Calibrate new servo motor, see
Calibrating the servo
motor .
6. Install new servo motor, see Installing the servo motor .
7. Install wall plate, see Installing the wall plate .
Replacing the wall plate with electronics , see fold-out
page III
1. Remove wall plate, see Fig. [23].
2. Disconnect plug-in connectors from electronics (C) to
extension cable (D) and to servo motor (P), see Fig. [26].
Assemble in reverse order.
Replacement parts , see fold-out page I (* = special
accessory).
Care
For directions on the care of this fitting, please refer to the
accompanying Care Instructions.
Fault / Cause / Remedy
Fault Cause Remedy
Illuminated frame not lighting • Power failure - Reconnect power supply
• Switched-mode power supply defective - Replace switched-mode power supply,
see Replacing the switched-mode power
supply
• Plug-in connector without contact - Attach plug-in connector
• Lighting switched off - Switch on lighting, see Switching on the
lighting using button T1
• Timer not activated - Activate timer, see Activating the timer
using button T1
Illuminated frame is not
switched on at desired time • Incorrect time set - Set time, see Setting the time
• Incorrect start time set for lighting - Set start time for lighting, see Setting
the start time for lighting
• Extended power failure (more than 1 hour) - Reset time, see Setting the time
• Summer/winter time changeover - Reset time, see Setting the time
Illuminated frame lighting for
too long/not long enough • Incorrect lighting duration set - Set lighting duration, see Setting the
lighting duration
Illuminated frame not lighting
with correct colour - Select and store lighting colour again,
see Selecting the colour using button T3
and Switching the colour using button T2
Illuminated frame not lighting • Incorrect start time set for lighting - Set start time for lighting, see Setting the
start time for lighting
• Incorrect lighting duration set - Set lighting duration, see Setting the
lighting duration
• Continuous lighting set - Activate timer, see Activating the timer
using button T1
4 LEDs flashing continuously • The timer is activated and the time is no
longer correct due to an extended power
failure
- Deactivate timer, using button T1 and
reset time, see Setting the time