3
Install the faucet:
Position the faucet and sealing ring on top of the
mounting surface. From beneath, install the plastic
washer, slide washer and metal washer. Thread on
the collar nut loosely.
If the total thickness of the mounting surface is greater
than 1 3/8”, omit the plastic washer.
Inspect the placement of the faucet. Reposition if
necessary.
Preparation for Installation:
Turn the water supplies off before removing the old faucet.
Flush the supply lines of debris before beginning installation. Damage to the cartridge
caused by debris is not covered under the Hansgrohe limited lifetime warranty.
The spout should swivel equally to the right and to
the left. If it appears to swivel more to one side than
to the other, pivot the faucet body until the swivel is
even.
When you are satisfied that everything is oriented
properly, finish tightening the collar nut. Tighten the
tensioning screws.
