Groen NFPC series, Руководство оператора

Страница: 10 / 24

OM-NFPC
10
check such parts as the undersides of the
cover, the electrical console and other more
remote spots. Clean between the pan
body and the control console using the
brush provided (P/N 058705).
g. To remove materials stuck to the
equipment, use a brush, sponge, cloth,
plastic or rubber scraper, or plastic wool
with the cleaning solution. To make
washing easier, let the cleaning solution sit
in the unit and soak into the residue, or
heat the solution briefly. Do
not use any
gritty cleaner or metal tool that might
scratch the surface. Scratches make the
surface harder to clean, and also provide
places for bacteria to grow. Do
not use
steel wool. Small bit of steel wool left in
the surface of the unit can cause rusting
and pitting.
h. The outside of the unit may be polished
with a recognized stainless steel cleaner
such as Zepper from the Zep
Manufacturing Company.
i. When the equipment needs to be
sanitized, use a sanitizing solution
equivalent to one that supplies 100 parts
per million available chlorine. Get advice
about the best sanitizing agent from you
supplier of sanitizing products. Following
supplier instructions, apply the sanitizing
agent after the unit has been cleaned and
drained. Thoroughly drain off the sanitizer.
CAUTION
NEER LEAVE A CHLORINE SANITIZER IN
CONTACT WITH STAINLESS STEEL
SURFACES FOR LONGER THAN 30
MINUTES. LONGER CONTACT CAN CAUSE
CORROSION.
j. After the unit has been cleaned, sanitized
and drained, let all surfaces air dry unless
the unit must be used again right away.
k. It is recommended that the unit be
sanitized just before use. Follow the
directions of the sanitizer supplier.
l. About once a week (more often if the
water is very hard), use a heavy duty
cleaner to remove any mineral deposits or
film left by hard water or foods. Follow the
supplier’s directions very carefully, and
rinse the unit off thoroughly as soon as
cleaning is finished.
m. If especially difficult cleaning problems
persist, contact your cleaning product
supplier for help. The supplier has a
trained technical staff with laboratory
facilities to serve you.
Maintenance
WARNING
USE OF REPLACEMENT PARTS OTHER THAN THOSE SUPPLIED BY GROEN OR THEIR
AUTHORIZED DISTRIBUTORS CAN CAUSE INJURY TO THE OPERATOR AND DAMAGE
TO THE EQUIPMENT AND WILL VOID ALL WARRANTIES. SERVICE PERFORMED BY
OTHER THAN FACTORY-AUTHORIZED PERSONNEL WILL VOID ALL WARRANTIES.
Your Braising Pan is designed to require
minimum maintenance, but certain parts may
require replacement after prolonged use. After
installation, no user adjustment should be
necessary. If a service need arises, only
authorized personnel should perform the work.
Service personnel should check the unit at least
once a year. This should include inspecting
electrical wires and connections and cleaning
inside of the control console. A Maintenance
and Service Log is provided at the rear of this
manual. Each time work is performed, enter the
date on which it was done, what was done, and
who did it
.
WARNING
ELECTRICAL POWER MUST BE SHUT OFF
BEFORE WORK IS DONE ON INTERNAL
COMPONENTS.