INSTALLATION INSTRUCTIONS
FOR GROEN CASTER KIT (Groen Part #098611)
CC10 AND C/2 STANDS
WARNING:
1. WHEN INSTALLING ON A
GAS COMBO OVEN,
THESE CASTERS MUST BE
INSTALLED WITH A GROEN GAS QUICK DISCONNECT SUPPLY KIT (GROEN PART
#140144) OR A GAS HOSE WITH MAXIMUM LENGTH THAT IS LONGER THAN THE
RESTRAINING CABLE.
2. WHEN INSTALLING ON AN
ELECTRIC COMBO OVEN,
LENGTH OF FLEXIBLE
CONDUIT MUST BE LONGER THAN THE RESTRAINING CABLE.
INSTALLATION PROCEDURE-
1. Raise the combo oven stand about 8” above the ground.
WARNING: Support the combination oven securely before lifting so that it does not tilt.
2. Remove the factory installed bullet feet.
3. Insert casters into place.
4. Level the combo oven front to back and left to right by adjusting the casters accordingly.
Figure 11 Figure 12
5. Drill a 13/32” (0.406” or 9 mm) diameter hole through one of the rear legs of table
approximately 3” to 6” below the top of table and near the steam outlet box as shown on
Figures 12.
6. Attach eyebolt, washers, lockwasher and nut to the table as shown on Figure 11.
GROEN CASTER KIT
7
