Groen DHS-40, Руководство оператора

Страница: 9 / 40

OM-DHS 9
Initial Start-Up
Now that the kettle has been installed, you should test it to ensure that the unit is
operating correctly.
1. Remove literature and packing materials from the interior and exterior of the unit.
2. If the unit is equipped with a draw-off valve (product outlet), clean out any material
which might clog or damage the draw-off.
3. Confirm that the tilting mechanism is operating properly by tilting the kettle
through its full range. Then return the kettle to the upright position.
4. Turn on the electrical service to the unit.
5. Pour 1-2 gallons of water into the kettle.
6. Following “To Start Kettle” instructions in the “Operation” section (Page 10), begin
heating the water at the highest thermostat setting. The heat indicator light should
come on, and heating should continue until the water boils.
If the unit functions as described above, it is ready for use. If it does not, contact your
local Authorized Service Agency.
WARNING
WATER IS EXTREMELY HOT AND CAN CAUSE
SEVERE BURNS. AVOID CONTACT WITH HOT
WATER WHEN EMPTYING UNIT.
WARNING
DO NOT STAND ON OR APPLY UNNECESSARY
WEIGHT OR PRESSURE ON THE KETTLE
FRONT OR POURING LIP. THIS COULD RESULT
IN THE OVERLOAD AND FAILURE OF THE
TILT MECHANISM, AND POSSIBLE
SERIOUS INJURY AND BURNS TO
THE OPERATOR AND OTHERS.
Correct water level