Grizzly T32720, Руководство пользователя

Страница: 17 / 40

Model T32720 (Mfd. Since 06/21)
-15-
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the switch disabling key disables the switch
properly.
3. Connect machine to power supply.
4. Move ON/OFF switch up to turn machine ON
(see Figure 12).
5. Verify motor operation by slowly turning vari-
able-speed dial clockwise. Rotate dial back
and forth to test variable-speed function.
Motor should run smoothly and without
unusual vibrations or noises.
6. Turn variable-speed dial all the way counter-
clockwise, then move ON/OFF switch down
to turn motor
OFF.
7. Remove switch disabling key (see Figure 12).
8. Try to start machine with ON/OFF switch.
The machine should not start.
— If machine does not start, switch dis-
abling feature is working correctly.
Congratulations! Test Run is complete.
— If machine does start, immediately stop
machine. Switch disabling feature is not
working correctly. This safety feature must
work properly before proceeding with reg-
ular operations. Call Tech Support for
help.
Figure 12. Control panel components.
ON/OFF
Switch
Variable-Speed
Dial
Switch
Disabling
Key
To test run machine:
1. Clear all setup tools away from machine.
2. Turn variable-speed dial all the way counter-
clockwise and make sure ON/OFF switch is
in OFF position (see
Figure 12).