-2-
Model T32713 (Mfd. Since 08/21)
To install negative pressure gauge:
1. DISCONNECT DUST COLLECTOR FROM
POWER!
2. Place (2)
1
⁄
2
" hose clamps around clear tube,
then slide one end of tube over port on back
of pressure gauge (see
Figure 3).
4. Place (2) 1
1
⁄
2
" hose clamps around dust
hose, then slide one end of hose over (1) 1
1
⁄
2
"
port on T-fitting (see
Figure 5).
5. Remove (2) flange nuts from hex bolts on
pressure gauge assembly (see
Figure 6).
6. Spread jaws of pressure gauge mount just
enough to slide mount over support leg near
magnetic switch, as shown in
Figure 6.
3. Slide other end of clear tube over
1
⁄
2
" port on
T-fitting (see
Figure 4).
Figure 4. Clear tube placed over T-fitting port.
Clear Tube
T-Fitting
1
⁄
2
" Port
Figure 5. Dust hose placed over T-fitting port.
T-Fitting
Hose Clamp
Dust Hose
Figure 6. Pressure gauge mount placed on
support leg (G0861 shown).
Support Leg
Hex Bolt
(1 of 2)
Pressure
Gauge
Mount
Note:
Position of pressure gauge mount
on support leg will differ from machine to
machine. Place mount near port on intake
barrel where pressure gauge will be visible
during operations.
Figure 3. Clear tube placed over pressure gauge
port.
Hose Clamp
Clear Tube
Pressure Gauge
Assembly
