-16-
Model T32305 (Mfd. Since 08/20)
Using Hydraulic
Control Lever
When you press and hold the ON button, the
electric motor pressurizes the hydraulic fluid with-
in the hydraulic tank. When you push and hold the
hydraulic control lever down, the pressurized fluid
moves the hydraulic ram forward, driving the log
into the splitting wedge. To operate the log splitter,
you must activate both controls simultaneously
(see
Figure 5).
Always use the log splitter in a well-lit area and on
a flat, stable work surface. Also, make sure work
area is clear of logs that may become tripping
hazards while using the machine.
Locate the log splitter as close as possible to the
logs you will split. Refer to
Extension Cords on
Page 11 for the minimum gauge and maximum
length of extension cord you can use with this log
splitter.
To split a log:
1. Turn air bleed screw clockwise until it stops,
then turn it counterclockwise two full turns.
2. Put on safety glasses, leather work gloves,
and leather work boots.
3. Place log lengthwise on table, against face of
hydraulic ram (see
Figure 6).
DO NOT attempt to split a log against the
grain by placing it sideways on the table.
Doing so may cause logs to fly off splitter
with great force, resulting in serious injury
or death.
Splitting Logs
This log splitter is ONLY designed
to split wood with the direction of the
grain. DO NOT attempt to split or crush
wood against the grain, or crush brick,
concrete blocks, or rock. If you do, you will
damage the machine, void the warranty, and
possibly severely injure or kill bystanders
or yourself.
Figure 5. Location of log splitter controls.
ON Button
Hydraulic
Control Lever
Figure 6. Log correctly placed on log table.
Log Table
Hydraulic Ram
