Grizzly T31566, Инструкция по эксплуатации

Страница: 4 / 12

-4-
T31566 Mobile Base (Mfd. Since 08/19)
8. With the help of an assistant, or proper lifting
equipment, lift and position machine inside
mobile base (see
Figure 9).
Figure 9. Example of machine properly placed
inside mobile base.
9. Verify machine is properly seated on mobile-
base corner pads, it is free of wobbles, and
there is no deflection in mobile base.
—
Deflection: If any deflection exists, verify
all fasteners are securely tightened and
mobile base is properly assembled. If
this does not solve the problem, verify
machine does not exceed the rated weight
limit listed in
Specifications on Page 1.
— Wobbles: Wobbles can easily be elimi-
nated by placing an appropriately sized
shim between machine and mobile base
where needed.
If your machine is oddly shaped or too heavy to
lift into the mobile base, you can assemble the
mobile base around your machine as an alternate
option for assembly. Always have an assistant
stabilize the machine during assembly.
Assembling Base Around Machine
Items Needed Qty
Additional Person .............................................. 1
Open-End Wrench 13mm .................................. 1
Socket Wrench 13mm ....................................... 1
12" 4x4 Block ..................................................... 1
12" 2x4 Block ..................................................... 1
To assemble mobile base around machine:
1. Install foot pedal plunger and spring into each
corner bracket (see
Figure 10), and attach a
rubber foot (with M10-1.5 hex nut) to the bot-
tom of each foot pedal plunger.
Figure 10. Installing foot pedal plunger and
spring.
Spring
Rubber
Foot
Foot Pedal
Plunger
7. Secure each end of corner brackets with (2)
M8-1.25 x 16 hex bolts (see Figure 8).
Figure 8. Securing corner bracket with both hex
bolts.
Hex
Bolts
Side
Rail
BOTH hex bolts must be secured against
side rail in each end of corner brackets. DO
NOT load machine onto mobile base until all
bolts have been firmly tightened. Improper
tightening or only using one bolt can result
in collapse or tipping when moving machine
around later, which could result in crushing
injury or property damage.