Grizzly T27978, Инструкция по эксплуатации

Страница: 1 / 8

COPYRIGHT © JUNE, 2017 BY GRIZZLY INDUSTRIAL, INC. REVISED DECEMBER, 2018 (JL)
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#JH18676 PRINTED IN CHINA
For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
MODEL T27978
50-TON HYDRAULIC PRESS
INSTRUCTIONS
Figure 1. Model T27978.
EYE INJURY HAZARD!
Always wear safety glasses
during use to prevent
serious personal injury.
INJURY HAZARD!
When servicing, always dis-
connect tool from air to pre-
vent unexpected operation.
125 PSI
MAX AIR PRESSURE!
Exceeding this PSI may
result in injury/tool damage.
Description Qty
Additional People ................................................. 2
Safety Glasses .............................................. 1 Ea.
Open-End Wrenches 13, 16, 18, 19mm ...... 1 Ea.
ISO VG32 Hydraulic Oil ........................2.5 Quarts
Needed For Setup
Inventory
Description (Figure 2) Qty
A. Hydraulic Press Assembly (not shown) ...... 1
B. Base Supports ............................................ 2
C. Pump Handle .............................................. 1
D. Support Rods ............................................. 2
E. Press Blocks ............................................... 2
F. Angle Braces .............................................. 4
G. Hardware Bag (not shown)
• Hex Bolts M10-1.5 x 25 ....................... 12
• Cap Screws M8-1.25 x 30 .................... 4
• Lock Washers 8mm ............................ 12
• Flat Washers 8mm ............................. 12
• Hex Nuts M10-1.5 ............................... 12
Figure 2. Inventory items.
F
E
D
C
B
Open shipping crate and remove inventory items
included inside (see
Figure 2).
Workpieces positioned off-center below
hydraulic ram can be ejected unexpectedly
from force being applied unevenly, striking
operator or bystanders with great force.
Always ensure workpiece is positioned
so force is evenly distributed. STOP and
release compression if workpiece shifts
during pressing.