Grizzly T27665, Инструкция по эксплуатации, Страница: 5 / 8

T27665 (Mfd. 01/16)
-5-
Wipe the arbor press down with a clean shop rag
and mineral spirits. When dry, protect the unpaint-
ed surfaces by applying a thin film of ISO 32 oil. Grease ..................T23964 or NLGI#2 Equivalent
Grease Amount ................................. As Needed
Lubrication Frequency .........40 Hrs. of Operation
Tools Needed Qty
Open-End Wrench or Socket 12mm ................. 1
To grease rack and pinion:
1. Remove front plate, then remove ram to
expose pinion and rack (see
Figure 9).
2. Use shop rags, a stiff brush, and mineral spir-
its to clean teeth of rack and pinion.
3. When dry, apply a light coat of grease to rack
and pinion teeth.
4. Re-install ram and front plate.
5. Use ram handle to move ram up and down
several times to distribute grease.
Figure 9. Ram rack and pinion exposed after
removing front plate.
Pinion
Ram
Rack
Cleaning & Protecting
Oiling Pinion Hub Shaft
Push the tip of the oil can nozzle against the oil
access hole and pump oil can once or twice. If
you see sludge and contaminants coming out
of the lubrication area, continue pumping the oil
can until the oil runs clear. Move the components
through the entire path of travel a few times to
distribute the oil. When finished, wipe away the
excess oil.
Figure 8. Location of oil access holes for
lubricating pinion hub shaft.
Oil Access
Holes
Oil Type .................T26685 or ISO 32 Equivalent
Oil Amount ......................................... 1–2 Pumps
Lubrication Frequency ...........8 Hrs. of Operation
Proper lubrication of the pinion hub shaft is done
with a pump-type oil can with a cone tip through
the oil access holes (see
Figure 8).
Greasing Ram Rack and Pinion