Grizzly T27577, Руководство пользователя

Страница: 20 / 32

-18-
Model T27577 (Mfd. Since 3/16)
Replacing V-Nail
Driver
The V-nail driver will eventually require replace-
ment due to normal wear and tear as the machine
is used. The V-nail driver may need replacing
if V-nails easily jam in V-nail block, or if driver
becomes jammed inside V-nail block channel,
which signals driver is worn. Because the V-nail
driver is considered to be a wear item, normal
wear and tear is not covered under warranty. It
is important to keep the V-nail driver and V-nail
block clear of debris and adhesive buildup to pro-
long its life.
Tools Needed Qty
Open-End Wrench 8mm.................................... 1
Hex Wrench 3mm .............................................. 1
Magnetic Pen Tool ............................................. 1
To replace V-nail driver:
1. Loosen cap screw securing V-nail driver (see
Figure 28).
Figure 28. Location of cap screw that secures
V-nail driver assembly.
2. Loosen hex bolt securing V-nail block, and
remove block from work table.
3. Move vertical clamp aside, and lower pres-
sure pad all the way down.
4. Press foot pedal. Vertical clamp will contact
work table and driver will move into view.
5. Remove old driver and install new driver.
IMPORTANT: Ensure driver orientation is
correct. V-shape lip must point toward center
of V-nail block (see
Figure 31).
6. Press driver into place and tighten cap screw.
7. Re-insert V-nail block and tighten hex bolt.
Figure 30. Removing driver from work table.
V-Nail
Block
Driver
Figure 31. Driver orientation in V-nail block.
Driver
V-Nail
Block
Figure 29. Removing V-nail block.
Hex Bolt
V-nail
Block
V-Nail
Driver
Cap Screw