Grizzly T27577, Руководство пользователя

Страница: 15 / 32

Model T27577 (Mfd. Since 3/16)
-13-
Changing V-Nails
V-nails work in tandem with adhesive to support
each corner of the workpiece when inserted from
the backside of the frame (refer to
V-Nail Size &
Placement).
Tool Needed Qty
Magnetic Tool .................................................... 1
To change V-nails:
1. Pull nylon cord loop and secure it around cap
screw on work table (see
Figure 13).
Figure 13. Pulling nylon cord to remove V-nails.
2. Use magnetic tool to retrieve remaining
V-nails in V-nail channel (see Figure 14).
3. Turn V-nail height dial to correct millimeter
size for the length of V-nails to be installed.
Insert new strip of V-nails with glued side fac-
ing up (see
Figure 14), and release cord.
Figure 14. Retrieving unused V-nails and
adjusting V-nail height dial.
15
12
10
7
5
V-Nail
Channel
Cord
Loop
Cap
Screw
V-Nails
Clamp Settings
The Model T27577 features two hold-down
clamps. Proper clamp setup ensures consistent
V-nail placement and machine function.
The vertical clamp secures the frame as a V-nail
is inserted into the workpiece. When either large
foot pedal is pressed, the pressure bar supporting
the top clamp lowers to the workpiece, securing
the frame. As the top clamp secures the frame,
a V-nail is inserted into the bottom side of the
workpiece. For best results, top clamp should be
set 10–20mm above workpiece before the foot
pedal is pressed (see
Figure 15).
The front clamp is spring-loaded and presses the
workpiece against the fence. When pressed, the
small foot pedal retracts the front clamp jaws from
the fence, allowing the workpiece to move. When
the pedal is released, the front clamp secures
the workpiece against the fence. For best results,
the front clamp should be set 3–9mm from the
workpiece (see
Figure 17).
1. Attach appropriate pressure pad to pressure
bar.
2. Position workpiece against fence.
3. Center pressure pad over workpiece, and
tighten pressure bar lock handle.
4. Press quick-release button and lower pres-
sure pad 10–20mm above workpiece (see
Figure 15).
Figure 15. Adjusting pressure pad above
workpiece.
Quick-Release
Button
Adjusting Vertical Clamp
10–20mm
Gap
Lock
Handle