-2-
T25953 T-Slot Table (Mfd. Since 10/17)
Assembly
Before beginning the assembly process, refer to
Needed for Setup and gather all listed items.
3. Attach (4) short braces to side assem-
bly with (8) M8-1.25 x 12 carriage bolts,
(8) 8mm flat washers, and (8) M8-1.25 hex
nuts (see
Figure 5). Finger-tighten hex nuts
for now.
1. Build one side assembly for stand by
attaching (2) long braces to (2) legs with
(8) M8-1.25 x 12 carriage bolts,
(8) 8mm flat washers, and (8) M8-1.25 hex nuts
(see
Figure 4). Finger-tighten hex nuts for
now.
Note: Orient lip of each long brace upward,
and secure long braces to inside edge of legs
(see inset).
To assemble T-slot work table:
2. Repeat Step 1 to build a second side
assembly.
Figure 4. 1 of 2 side assemblies for stand.
x 8
Lip
(Each Side)
Figure 5. Short braces attached to side
assembly.
Lip
x 8
Short
Braces
4. Attach second side assembly to short brac-
es with (8) M8-1.25 x 12 carriage bolts,
(8) 8mm flat washers, and (8) M8-1.25 hex
nuts (see
Figure 6). The lips of the short
braces normally overlap the lips of the long
braces (see inset of
Figure 6).
Leg
Hole
Side
Assembly
Figure 6. Second side assembly attached to
short braces.
x 8
Second
Side
Assembly
Long Brace
End View
