t23084 (Mfg since 11/10)
-5
-
using grinder
always test the grinder on a scrap piece
of material similar to the workpiece to
determine the ideal setup.
to use the grinder:
1. Make sure the workpiece is securely
held in a vise or a similar device that
will ensure the workpiece does not
unexpectedly move during operation.
2. attach the grinder to an air supply set
at no more than 90 psi.
3. hold the grinder securely, turn the
grinder
ON by depressing the trigger,
then ease the grinding wheel against
the workpiece with a light, but steady,
pressure.
note: The pressure applied to the trig-
ger varies the grinder speed.
4. to turn the grinder OFF, release the
trigger.
note: To avoid accidental start up,
disconnect the grinder from the air sup-
ply when it is not in use. Replace the
protective cap over the air inlet port to
keep dust or debris out of the internal
components.
daily maintenance
the angle grinder Must have 4-5 drops
of pneumatic tool oil directly dropped into
the air inlet port before and after each
use. in addition, add oil after 1–2 hours
of continuous use or install an in-line
filter, lubricator, and regulator, as shown
in
figure 3.
these procedures should be done after
each use:
•
Wipe the grinding housing with a dry
cloth, or blow off the dust and debris
with compressed air.
•
Check for damage to grinding wheels,
hoses, housing, or other accessories.
Quick
Connector
Quick
Coupler
Air Hose
Quick
Coupler
Quick
Connector
Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
figure 3. installed filter lubricator
regulator.
eye inJury
hazard!
Wear protective
equipment when
using this tool.
accidental start
hazard!
disconnect before
service or tool
changes.
air pressure
hazard!
never exceed max
psi rating for tool.
lung/ear inJury
hazard!
Wear protective
equipment when
using this tool.
