-16-
Model h2935/h2936 (Mfg. since 2/12)
Figure 5.
Minimum working clearances.
Floor Load
refer to the
Machine Data Sheet
for the weight
and footprint specifications of your machine.
some residential floors may require additional
reinforcement to support both the machine and
operator.
Working clearances
Consider existing and anticipated needs, size of
material to be processed through each machine,
and space for auxiliary stands, work tables or
other machinery when establishing a location for
your new machine. see
Figure 5
for the minimum
working clearances.
unsupervised children and
visitors inside your shop
could cause serious per-
sonal injury to themselves.
Lock all entrances to the
shop when you are away and
DO NOT allow unsupervised
children or visitors in your
shop at any time!
Site considerations
Assembly
components and Hardware Needed:
Qty
Foot pad screws ............................................... 4
hex nuts
3
⁄
8
"-16 ................................................. 4
Filter 16" x 20" x 1" ............................................ 1
Filter 16" x 20" x 2"(h2935) ............................... 1
Filter 16" x 25" x 2"(h2936) ............................... 1
downdraft plates (h2935) ................................. 4
downdraft plates (h2936) ................................. 5
pins ................................................................... 7
Center panel ...................................................... 1
left panel .......................................................... 1
right panel ........................................................ 1
handle ............................................................... 1
hex nut
5
⁄
16
"-18 .................................................. 1
phillips head screws
1
⁄
4
"-20 x
5
⁄
8
" ...................... 2
To assemble the downdraft sanding table:
1.
With an assistant's help, lay the back of the
downdraft table cabinet flat on the floor.
2.
thread a hex nut onto each foot pad screw,
then install the foot pads into the holes in the
bottom of the downdraft table, as shown in
Figure 6
.
Figure 6.
installing footpads
.
51¼"
56¼"
3.
With an assistant's help, return the downdraft
table to the upright position so it rests on the
footpads.
4.
Check to make sure all four footpads touch
the floor evenly. Adjust individual footpads if
necessary and secure the hex nuts against
the bottom of the cabinet with a 14mm
wrench.
65"
69"
H2935
H2936
Minimum
12" clearance
at outlet
Minimum
12" clearance
at outlet
