G6049 14/15 Gauge Angle Finish Nailer Kit
-5
-
Compressed Air System
Safety Yoke Mechanism
The safety yoke is a mechanical
device that can fail. Never rely on the
safety yoke mechanism as an excuse
to point the nailer at yourself or any
bystanders. Serious injury may occur.
Exceeding the maximum permissible
operating pressure may cause the
nailer to explode, blowing metal frag-
ments in all directions. To protect
yourself from serious personal injury,
DO NOT allow your air compressor to
exceed the recommended pressure
when connected to this nailer!
The Model G6049 is designed to be oper-
ated at 80-120 psi.
Do not exceed the
maximum operating pressure!
Before you use your new nailer, regulate
the air pressure on your air compressor to
barely over the minimum psi for your nail-
er. Increase air pressure only if needed.
Many pneumatic tools benefit from an in-
line filter/lubricator/regulator unit. This
attachment is connected by hoses
between the air compressor and the nailer.
Using this unit protects your tool from dam-
aging water build-up, allows you to adjust
and maintain constant air pressure to your
tool, and saves you the inconvenience of
having to manually lubricate your tool
every time you use it. Check the current
Grizzly catalog for availability of this unit. If
you plan on installing a filter/lubricator/reg-
ulator unit in your compressed air system,
always follow the connection instructions
that come with the unit.
A safety yoke mechanism (bump fire) on
the nose of the nailer acts as a safety
device. When the trigger is pressed, the
nailer will not fire until the safety yoke
mechanism is depressed.
Before you use your nailer for the first time,
check the safety yoke mechanism to
ensure proper function. To do this:
1.
Make sure the nailer is disconnect-
ed from the air supply!
2
.
Make sure the magazine is empty and
contains no nails.
3.
Make sure the trigger and the safety
yoke mechanism move up and down
without sticking.
4.
Connect the nailer to the air supply.
5.
Without pressing the trigger
,
depress the safety yoke mechanism
against a scrap piece of wood that is
clean and free of any knots, nails, or
other foreign objects. If the nailer
does not fire, then the safety yoke
mechanism is working correctly. If the
nailer
does fire
when you do this,
immediately disconnect the nailer
from the air supply and call our cus-
tomer service for help.
Similarly if the nailer fires when the trigger
is pulled,
without the safety yoke mech-
anism being depressed
, then the nailer is
not working properly.
If either of these two conditions develop
after you have used your nailer for a peri-
od of time, check the lubrication of these
mechanisms.
