G6049 14/15 Gauge Angle Finish Nailer Kit
-9
-
Cleaning Nailer
Use a good solvent to clean the nose
assembly of the nailer. Always be sure that
the nailer is dry before using it again.
Do not allow dust, chips, sand, etc. into the
air connectors or into the body of the nail-
er; this may result in leaks and damage to
the nailer and the air fittings.
Never use gasoline or other flamma-
ble liquids to clean this tool. Vapors
in the tool may ignite, causing the
tool to explode. Ignoring this warning
may lead to serious personal injury or
even death!
Always disconnect air from nailer
whenever servicing! During mainte-
nance, a nailer connected to air may
fire accidentally, causing serious
personal injury!
Oiling Nailer
The Model G6049 is considered an oil-less
model. This means it features a teflon pis-
ton ring that does not require oil to operate.
However, periodic applications of oil will
extend the useful life of the piston assem-
bly.
Special oil has been included with you new
Grizzly Nailer. Periodically place one drop
of oil in the nailer air inlet (as shown in
Figure 6
). After oiling, wipe off any excess
oil near the nailer exhaust to avoid dust
build-up. When the oil that was included
with the nailer has been completely used,
replace with Grizzly Model G2820
Pneumatic Tool Oil.
Another option to manual oiling would be
to install a lubricator in your air compressor
line. If your air compressor line already has
a lubricator, then regular lubrication of your
nailer will not be necessary. Just make
sure there is always oil in the lubricator.
As mentioned before, the best option is to
install a filter/lubricator/regulator unit such
as the Grizzly Model H2333 in your air line.
Figure 6.
Lubricating nailer via air inlet.
NOTICE
Too much oil in the nailer will ruin
the O-rings!
