G4017–20 (Mfd. 02/15+)
-3-
Mounting
Because of the dynamic forces involved in oper-
ating the arbor press, we strongly recommend
mounting it to a benchtop or other stable working
surface to prevent it from moving during operation
and causing accidental injury or damage.
The base of the arbor press has two,
3
⁄
4
" mounting
holes on each side of the upright (see
Figure 3).
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Figure 4. Example of a "Through Mount" setup.
Figure 5. Example of a "Direct Mount" setup.
Machine Base
Workbench
Lag Screw
Flat Washer
Another option is a "Direct Mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
Assembly
Tools Needed
Qty
Hex Wrench 3mm (G4017, G4018) .................... 1
Hex Wrench 4mm (G4019, G4020) ................... 1
Figure 6. Inserting pinion hub into arbor press.
Pinion Hub
1. Insert pinion hub into main body of arbor
press (see
Figure 6).
Figure 3. Mounting hole (1 of 2).
3
⁄
4
" Mounting Hole
(1 of 2)
Machine Base
Workbench
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
This arbor press arrives with the base plate
pre-installed at the factory. Follow these instruc-
tions for final assembly of pinion hub and handle
assembly.
