G1182 6" Heavy-Duty Jointer
-23-
XI. MAINTENANCE
C. LUBRICATION
Since all bearings are shielded and permanently
lubricated, simply leave them alone until they
need to be replaced. Do not lubricate them.
Table ways and the fence assembly should not be
lubricated. If the tables appear to be stuck, disas-
semble and clean any foreign materials from the
ways. Re-assemble and reset the gibs.
D. V-BELT
Inspect regularly for tension and wear; replace
when necessary with a size A-36 belt. Check pul-
leys to ensure that they are properly aligned. See
pulley/V-belt sections for proper tension and pul-
ley alignment procedures.
A. GENERAL
Regular periodic maintenance on your Model
G1182 Jointer will ensure its optimum perfor-
mance. Make a habit of inspecting your jointer
each time you use it. Check for the following con-
ditions and repair or replace when necessary.
1.
Loose mounting bolts.
2.
Worn switch.
3.
Worn or damaged cords and plugs.
4.
Damaged V-belt.
5.
Any other condition that could hamper the
safe operation of this machine.
B. TABLES
The table and other non-painted surfaces on the
Model G1182 should be protected against rust
and pitting. Wiping the saw clean after every use
ensures that moisture from wood dust isn’t
allowed to trap moisture against bare metal sur-
faces.
Some woodworkers recommend using automo-
tive paste wax on exposed steel and cast iron sur-
faces. The wax provides a layer of protection, as
well as reducing friction between lumber and the
table, making cuts faster and smoother. Avoid
waxes that contain silicone or other synthetic
ingredients. These materials can find their way
into lumber that’s being worked, and can make
staining and finishing difficult. If you use paste
wax, make sure that it’s 100% Carnauba wax.
DO NOT make adjustments while the jointer
is running. Ensure that the switch is off,
power is disconnected and moving parts
have stopped before making adjustments.
Failure to comply may result in serious per-
sonal injury.
