-10-
G1182 6" Heavy-Duty Jointer
3.
Position the dust chute base between the
dust chute sides (flanges up), carefully align-
ing the screw holes in the base and the
sides. Figure 4. The flanges should be inside
the chute.
Figure 4. Attaching the dust chute base.
4.
Attach the top of the stand to the sides and
dust chute. Note that the flanges for the top
are inside the stand (the flanges for the dust
chute opening should be outside the dust
chute, however) and that the opening for the
drive belt is at the rear of the stand. Figure
5.
5.
Flip the stand upside down to mount the
motor to the underside of the dust chute.
Mount the motor on the chute using the four
5
⁄
16
" - 18 x
3
⁄
4
" hex head bolts, flat washers
and nuts provided. Be sure to position the
motor pulley to the rear (open end) of the
stand as shown in Figure 6. Leave the motor
mount bolts finger-tight for now.
Figure 5. Attaching the top of the stand.
Figure 6. Attaching the motor.
Make sure the slots in the motor support
are toward the top of the stand.
VIII. ASSEMBLY (Continued)
