Grizzly G0923, Руководство пользователя

Страница: 28 / 56

-26-
Model G0923 (Mfd. Since 05/20)
Before printing, adhesive must be applied to the
build plate to ensure first layer of filament sticks
and does not warp.
To prepare build plate:
1. Use glue stick to apply thin layer of glue to
surface of build plate. Glue should be evenly
distributed, without noticeable chunks or high
points.
2. Slide build plate into build platform. Ensure
build plate slides fully into position (see
Figure 26).
Preparing Build Plate
Figure 26. Build plate with glue applied and in
position on build platform.
Preheating Nozzle
The nozzle must be preheated before changing
filament or starting a print. 200-205° C is the typi-
cal print temperature for PLA filament. Always use
temperature settings recommended by the fila-
ment manufacturer.
Preheating
1. Press control dial to open main menu.
2. Navigate to "Preheat" and press control dial
to start process. Display will return to status
screen and current temperature will begin to
change as nozzle heats up. Preheating stops
when current nozzle temperature matches
target temperature (see
Figure 27).
Figure 27. Preheating temperature indicators on
status screen.
Target
Temperature
Current Nozzle
Temperature
Canceling Preheating Process
1. Press control dial to open main menu.
2. Navigate to "Cooldown" and press control
dial to start cooldown process.
Changing Preheat Temperature
1. Press control dial to open main menu.
2. Use control dial to navigate to "Control" >
"Temperature" > "Preheat Conf" > "Nozzle."
3. Rotate control dial to change preheat tem-
perature. Press control dial to confirm.
Note: Changing preheat temperature does not
change print temperature. Once printing starts,
G-code controls the print temperature based on
print settings in the slicer software.