Grizzly G0900, Руководство пользователя

Страница: 54 / 68

-52-
Model G0900 (Mfd. Since 03/20)
Aligning Pulleys
Pulley alignment is important to the performance
of your shaper. If the pulleys are just slightly out of
alignment, the shaper may suffer from power loss
and decreased V-belt life. When the pulleys are
parallel and aligned with each other, they are said
to be coplanar—in the same plane.
Figure 75. Motor mounting bolts location.
Tools Needed Qty
Precision Straightedge ...................................... 1
To check alignment of pulleys:
1. DISCONNECT MACHINE FROM POWER!
2. Open cabinet access door.
3. Hold straightedge up to pulleys to determine
if they are both aligned and parallel, as
shown in
Figure 74.
— If pulleys are not parallel or aligned with
each other, perform appropriate steps in
following procedures.
Figure 74. Example of straightedge used to
check pulley alignment.
Aligning Pulleys
Tools Needed Qty
Precision Straightedge ...................................... 1
Precision Level .................................................. 1
Open-End Wrench or Socket 16mm ................. 1
To align pulleys:
1. DISCONNECT MACHINE FROM POWER!
3. Using straightedge as a guide, adjust height
of motor until pulleys are aligned, then re-
tighten hex bolts.
Note: When adjusting spindle alignment,
take not only spindle height into account, but
also consider motor and motor pulley angle in
relation to spindle (see
Figure 76).
4. Use level to check pulley angles, and adjust
hex bolts until parallel.
5. Replace motor access panel and ensure
V-belt is properly seated for desired speed
(see
Speed Changes on Page 25) before
reconnecting machine to power.
Same height,
different angle
Same height,
same angle
Figure 76. Spindle alignment height and angle.
2. Remove motor access panel, then loosen the
four motor mounting hex bolts, as shown in
Figure 75. It may be easier to access back
bolts from cabinet access door.
Mounting
Bolts
(2 of 4)
Checking Pulley Coplanarity