Model G0886 (Mfd. Since 01/19)
-21-
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
The Test Run verifies the following: 1) all motors
power up and run correctly, 2) the hydraulic
system runs correctly, 3) 3-phase power supply
polarity is correct, (4) the Emergency Stop button
safety feature works correctly, and (5) the lower
limit switch safety feature works correctly.
Refer to
Figure 19 during Test Run. Each control
has an alphabetical callout for identification.
Lubricating Machine
The gearbox must have the proper amount of
gear oil in it before the machine can be operated.
Refer to the
Lubrication section, beginning on
Page 43, for checking and adding gear oil.
IMPORTANT: Damage caused to the bearings,
and gears from running the machine without
gear oil in the gearbox will not be covered under
warranty.
GEARBOX MUST
BE FILLED WITH OIL!
MACHINE MAY NOT BE
SHIPPED WITH OIL!
Requires Oil
Before Operation
or Warranty Will
Be Void.
A
B
C
D
E
F
G
H
I
J
K
L
M
N
Figure 19. G0886 control panel.
Test Run
