Grizzly G0834, Руководство пользователя

Страница: 40 / 60

-38-
Model G0834 (Mfd. Since 12/17)
4. Open cutterhead pulley cover and rotate
cutterhead pulley until one cutterhead insert
is at top dead center (its highest point during
rotation), as shown in
Figure 45.
Bottom Dead
Center
Top Dead
Center
Figure 45. Cutterhead insert at top dead center.
Straightedge
Outfeed Infeed
Figure 46. Using straightedge to check outfeed
table height.
5. Place straightedge over center of outfeed
table so it hangs over cutterhead.
When correctly set, cutterhead insert will
barely touch straightedge when cutterhead
is rotated back and forth with pulley, as
shown in
Figure 46.
— If your outfeed table is correctly set, no
adjustments are necessary.
— If cutterhead insert lifts straightedge off
the table or it is below straightedge, then
outfeed table height must be reset.
6. Use outfeed table adjustment handwheel to
set outfeed table height so cutterhead insert
barely touches straightedge, as shown in
Figure 46.
7. Tighten outfeed table lock, and tighten
outfeed positive stop bolt and jam nut so
outfeed table will not move during operation.
8. Re-install cutterhead guard and fence
assembly, and close cutterhead pulley cover.
Figure 47. Infeed table even with outfeed table.
Straightedge
Infeed Outfeed
5. Precisely adjust scale pointer to "0", as
shown in
Figure 48.
Calibrating
Depth-of-Cut Scale
Items Needed Qty
Phillips Screwdriver #2 ...................................... 1
Precision Straightedge ...................................... 1
To calibrate depth-of-cut scale:
1. DISCONNECT MACHINE FROM POWER!
2. Perform Setting Outfeed Table Height on
Page 37.
3. Place a straightedge across infeed and
outfeed tables.
4. Adjust infeed table until even with outfeed
table, as shown in
Figure 47.
The depth scale can be calibrated or "zeroed" to
make sure the cutting depth shown on the scale
matches the actual cutting depth (per pass).
To calibrate the depth scale:
1. Set the outfeed table height as described in
Setting Outfeed Table Height.
2. Place a straightedge across the infeed and
outfeed tables.
3. Adjust the infeed table until it is level with the
outfeed table, as shown below.
4. Using a screwdriver, precisely adjust the
scale pointer to “0”.
Figure 48. Adjusting scale pointer to "0".
Scale
Pointer